Hi Fisherman and Mist: Here is my favorite "solution," except that I do not think it is a real solution. If Zodiac really transposed the mes…
O.k., that is fine. Still working on the general iterations versus restarts data.
There is a problem. Iteration after iteration there is no change, always the same null and skip positions, except it does change once in a while. The …
Yes, my last post was hastily done and in error. I looked closer, and there were EDIT: 6 iterations out of 9948 where there were a null and skip in th…
Here is the solve. Only a few positions where skips are in the same place ( lower graph ).
I just ran Jarlve 5/3 at 10k HC and 500k Sub three restarts and will check them for orbiting on the spreadsheet at lunch, however, I did already get o…
I will have an answer to your new version in about 7 hours at my lunch break.
You are saying that we need to optimize the ratio of HC iterations to GN iterations? Looks good. We need a unit of measurement, but it should be HC-GN…
Yes, my computer is going at it all of the time as well. Thanks.
Here is one with 10,000 iterations for the 5/3. Top chart orbiting by 0 positions ( same exact position ), second chart orbiting by 0-1 position, thir…
It is really a much larger square area than the picture, and the global maximum hill is, although the largest of all hills, proportionately much small…
What do you mean with 1 million iterations? A total number of 1 million hc iterations? Something like 20 x 50k versus 40 x 25k etc. Yes, 1 million hc…
Here is one, 7500 iterations Jarlve 5/3 shift 15% shift divisor 2. I added little vertical red lines at the sub restarts. They don’t line up exactly w…
I would like to see a before and after test with the fix of not allowing a null and a skip in the same place. At least with 500 restarts and initially…
The spreadsheet is getting bigger and more elaborate. I can now designate a position range for orbiting, and the symbols will highlight a pinkish colo…